Fits Australian wall switch plate apertures (For example, the Sylvania Trader Cougar range, plus HPM and Clipsal ranges)
Separately switched 2-wire design - no neutral wire connection required for wallplate retrofit installation
Rotary control with mechanical adjustment for minimum brightness level Minimum brightness typical 0%
"Soft-start” help prolong lamp and driver life. Thermal wind-back for overload and over-temperature protection.
Protected against damage from connection to incompatible inductive load types (i.e., motor loads), via conduction angle wind-back
Incorporates filtering to reduce load brightness variation under conditions of line voltage ripple signal injection.
Stable operation with most non-dimmable lamps (to a limited dimming level, lamp dependent)
Inherent immunity to installation wiring short circuit fault. Complies with all relevant Australian standards.
Features ‘On’ LED indicator Incorporates a thermal fuse
Basically the DIMPALA can Dim just about any lamp to a brightness of 100% down to 0 (yes 0%).
Plus it fits All Australian Gang plates